
FUEL CYLINDERS
100786-0 Rev. D 05/09
7
MOTHER TANK, TRANSFILLER & FUEL CYLINDER
CONNECTED FOR TRANFILLING
(Figure 2)
1. Remove the safety cap or caps from the fuel mother tank.
2. Very slowly, open valve on the fuel mother tank a very small
amount (crack). Then close it immediately. This will clean (blow)
any contaminants out of the valve.
3. Firmly secure the hex nut on the transller to the fuel mother tank
valve outlet using an appropriate wrench. (Note: notches in hex nut
body indicate the nut threads are “Reverse Cut” threads.)
4. Finger tighten knurled nut on transller to valve outlet on fuel
cylinder.
5. Close bleed off valve on transfiller by turning it completely
clockwise.
6. Slowly open fuel mother tank valve counterclockwise until the
pressure gauge on the transller continues to rise, or approximately
one-half of a turn open.
7. Observe transller pressure gauge and turn off fuel mother tank valve
at 1750 psig or when the pressure gauge stops rising below 1750 psig
Kommentare zu diesen Handbüchern